A finished design still needs to be enabled for the correct store address. Check saving, installation and the publication switch so customers can see the campaign you prepared.
Our example publishes the DEMO STORE email signup popup. The same address-selection steps apply to other onsite campaigns.
Check the design and installation
In the editor, wait for Everything is saved, then complete the pre-publication check. Saving concerns the design; it does not confirm that DropUI's script is already working on the store website.
Open the campaign details in the dashboard and choose Publication. Check the campaign name and Where should the campaign appear?. Here you choose a store address, not an individual page from a display rule.
If the address says Waiting for installation, open Store installation and finish setup. Then use Check again. Enabling the switch does not replace installing the script on the website.
Launch the campaign
- Confirm the store and address. If you manage several stores, do not choose only by a similar name.
- Turn on the switch beside the address where the campaign should run. Address-selection changes take effect immediately; this is not just a selection for a later test.
- Check the response and campaign summary. If an error appears, do not treat the selected switch alone as confirmation of publication.
- Open the store in a new private window and meet the display rule. In our example, wait 10 seconds on a page covered by the campaign.
An active status does not mean everyone sees the popup immediately. Page, audience, schedule and frequency settings still apply.
Update a running campaign
Choose Edit campaign, make your change and wait for saving to finish. Check Preview, Publication and the store website again. If the summary reports an update problem or offers a retry, resolve it before treating the new version as available.
For a larger change, you can first disable the campaign beside the store address, finish editing and enable it again after testing. Disabling publication does not delete the design.
If the campaign does not appear
Check installation, the publication address and the opening trigger. Use a fresh private window because a previous dismissal or signup may prevent another display. If an error remains, keep its text, the page address and campaign name; these details help support investigate it.

