Skip to content
Documentation
DropUI homepage
Topics

Activate, pause or delete an onsite campaign

The design is ready, but the offer should start only after it has been checked? Separate saving content from making it available in the store. A campaign can exist in the dashboard without being shown to shoppers.

Check the campaign and store

Open the appropriate onsite format. Confirm the name, store and website address before opening the campaign details.

Demo campaign details and its publication settings.

The list status helps distinguish active and disabled campaigns. It does not establish that a particular visitor meets the display rules. Installation, schedule and audience restrictions still apply.

Enable after checking the preview

Wait for the editor to finish saving. Follow the publication steps and choose the correct store or address. If the panel reports a missing installation or an unready release, complete that step first.

After enabling, open the store and perform the configured trigger. A working editor preview does not establish that the store loads the campaign.

Open Publication -> Where should the campaign appear? in the campaign details and turn off the switch for the address. To stop it across the store, check every enabled address, then open the site to confirm the result.

Pause an offer

Disable the campaign when the promotion ends or its content needs work. If it is published on several addresses, check the scope of that change. Pausing preserves the design.

This does not recall a code already copied or a message already read. Discount eligibility must also be enforced by the store.

If the campaign belongs to an active A/B test, check the test as well. Its distribution is a separate part of the configuration.

Delete only an unwanted design

Deleting an onsite campaign removes the project; it is different from pausing it. Read the confirmation and check its name and connections first. Keep a campaign disabled if you expect to use it again.

Automations and Feed cards have separate removal rules. Do not assume their history and recovery behavior applies to this project.

Have questions after reading this guide?

Get in touch. We’ll answer your questions and help you with setup, free of charge.

Patryk Surmacz

I’ll walk you through the settings, step by step.